Charging the battery
Before the battery is used for the first time, it should be charged in the PowerUnit for around 4 hours in order to activate maximum power in the battery.
The maximum battery capacity is achieved once the battery has been charged and run down five times.
We recommend allowing the battery to run down completely before recharging it. In this way, you will benefit from the battery’s full capacity.
Charge the battery at an ambient temperature between 10 °C and 40 °C.
Charging the Triflex battery:
Once the battery is fully charged, the battery charging state indicator switches off after 10 minutes to conserve energy.
If the battery is run down and has not been used for a long time, it will switch to safe mode to prevent deep discharge. As a result, the rechargeable battery status indicator will only respond after approximately 30–60 minutes.
Remove the sticker from the battery.
Push the battery along the guide lines until it audibly clicks into place in the PowerUnit.
If you want to separate the sections again, press both release buttons at the side of the battery to remove the battery.
Plug the charging plug of the supplied charging cable into the charging socket on the bottom of the battery.
Plug the charger into a power socket.
The charging process will start.
Charging the Duoflex battery:
Plug the charging plug of the supplied charging cable into the charging socket on the bottom at the rear of the PowerUnit.
Plug the charger into a power socket.
The charging process will start.
