Water is not being pumped away (G1xxx–G6xxx)

Clean the filter combination as follows:

• Switch the dishwasher off.

• 

• Turn the handle anti-clockwise to release the filter combination.

• Remove the filter combination.

• Remove and dispose of any coarse soiling.

• Rinse the filter under running water.

Clean the inside of the filter as follows:

• When you are fitting the filter combination, take care that it is secured in position correctly.

• 

• Press the recessed grips together in the direction of the arrows (1). Keep the recessed grips held and open the filter flap (2).

• Rinse all the parts under running water.

• Then close the flap on the inside of the filter so that the catch fully engages.

• 

• Replace the filter combination so that it lies flat in the base of the wash cabinet.

• Turn the handle of the filter combination clockwise until both arrows point towards each other.

Remove the non-return valve. Proceed as follows:

• 

• Press the catch on the non-return valve inwards (1).

• Tip the non-return valve inwards to release the cover (2).

Replace the non-return valve by placing it down vertically from above.

Make sure that the non-return valve is flush with the edge.

Clean the drain pump. Proceed as follows:

1. Risk of injury from glass splinters.

   It is especially difficult to see glass splinters in the drain pump.

   Take care when cleaning the drain pump.

2. Switch off the dishwasher and unplug the plug.

3. Remove the filter combination from the wash cabinet.

4. Scoop the water out of the wash cabinet using a small container.

5. Clean the drain pump. Proceed as follows:

   • 

   • Press a small sponge through the drain pump impeller.

   • Carefully remove all foreign objects from the drain pump.

   • Check the drain pump impeller by manually turning it.

6. 

7. Ensure that the catch on the non-return valve engages completely.

8. Replace the non-return valve by placing it down vertically from above.

   • Make sure that the non-return valve is flush with the edge.

9. Refit the filter combination correctly.

   • Ensure that the filter combination lies flat in the base of the wash cabinet.

10. Start the wash programme again.

11. Check whether the water has been pumped away.

Remove any kinks or loops from the drain hose.

Keep an eye on any points where kinks were present for a while afterwards, as the plastic may tear here.

Check the hose for blockages and try to remove them.

Additionally, clean the on-site drain and the siphon.

If the fault persists, please contact us or book a repair appointment online.